When greenhouse crops receive too little light, photosynthesis slows and the plant makes fewer sugars for growth, flowering and fruit set. The result is weaker, stretched plants, lower yield and poorer quality. How severe the loss is depends on the crop, cultivar, growth stage and how long the shortage lasts.
Low light is most common in winter and in regions with limited daylight. Below, we explain how it affects the plant, what you can see in the crop, where the losses show up, and how to correct it.
How does low light disrupt plant growth processes?
Low light reduces photosynthesis, so the plant makes fewer assimilates (sugars) to fuel growth. With less energy available, the crop slows the development of roots, leaves, flowers and fruit, and it starts to shift resources between plant parts.
Light is the energy source for the whole plant. When the light reaching the leaves falls below what the crop needs, several things change at once. The plant still needs energy for respiration, so less sugar is left for new growth. The smaller supply must be shared between vegetative growth (leaves and stems) and generative growth (flowers and fruit), and fruits, flowers and roots often compete for the same limited energy. Plants also tend to stretch towards the light and form thinner, larger leaves to catch more of it. Lower light also changes water use, which can affect how the crop takes up nutrients and calcium.
It helps to separate two measurements here. PPFD (photosynthetic photon flux density) is the light intensity at the crop at a given moment, measured in µmol/m²/s. DLI (daily light integral) is the total light the crop can use for photosynthesis over a whole day, measured in mol/m²/day. A greenhouse can have a reasonable PPFD at midday but still end up with a low DLI because of short, dark winter days. Both matter when you assess a light shortage.
What are the visible signs of light deficiency in crops?
The most common signs of too little light are stretched, thin stems, pale or thin leaves, slow growth and weak flowering. These often appear gradually, so many growers notice them only after the crop has already fallen behind.
In the crop, you may see long distances between leaves and thin stems as the plant reaches for light. Leaves can look pale or light green, and they may be larger but thinner than normal, because the plant increases its leaf area to capture more light. Growth and development slow down, which means longer cropping cycles and later harvests. Flowering can suffer through poor flower initiation, flower drop or small flowers. Plants may also become soft and weak, so they lodge or break more easily and may be more sensitive to disease.
Be careful with diagnosis. Stretching can also come from high temperatures, high humidity, dense planting or a poor day/night temperature balance. Check light measurements alongside the climate data before you decide that light is the cause.
How much yield and quality is lost to low light?
Less accumulated light generally means less production, and growers often see this clearly in winter. However, the exact loss depends on the crop, growth stage and how long the shortage lasts, so no single figure fits every greenhouse.
Yield loss from low light usually shows up in several ways. Total yield falls through fewer or smaller fruits, fewer stems or lower fresh weight. In leafy greens, propagation and pot plants, crops take longer to reach a saleable stage. Quality can also drop, for example through weak stems in cut flowers, poor colour, lower sugar content in fruit and less compact plants. Uneven growth makes grading and planning harder, and plants with a weak carbon balance may cope less well with climate swings or disease pressure.
Light is only one factor. Temperature, CO₂, water, nutrition and climate management all influence the result. This is why the same light shortage can cost one grower much more than another.
Which greenhouse crops suffer most from too little light?
Crops with a high light demand, such as tomatoes, cucumbers, strawberries and many cut flowers, tend to suffer most when light is short. Young plants in propagation and crops grown through winter are also sensitive, because they depend on steady light for compact, even growth.
Fruiting vegetables such as tomatoes and cucumbers carry heavy fruit loads, so a low carbon supply can affect fruit set, fruit size and the balance between vegetative and generative growth. In strawberries, flowering, fruit quality and sugar content respond to the available light, especially in winter and early spring greenhouse production. In cut flowers such as roses and chrysanthemums, stem length, stem strength and flower quality all depend on enough light. Leafy greens respond quickly to light, so low light lengthens the cropping cycle. Seedlings and cuttings need good light for rooting and compact growth.
Some ornamental and shade-tolerant pot plants need far less light. Always compare against the requirements of your own crop and cultivar rather than a general rule.
When is natural light not enough in a greenhouse?
Natural light is not enough when the daily light your crop receives falls below its DLI requirement. This happens most often in autumn, winter and early spring, at higher latitudes, and during long spells of cloud, especially for crops with a high light demand.
Several factors decide how much natural light actually reaches your crop. Location and season matter, because day length and sun angle change strongly through the year. A run of overcast days can lower the DLI well below the crop’s needs. The greenhouse itself also plays a role: glass type, coatings, roof structure, screens and equipment all reduce transmission, and dirty or ageing glass lets in less light. Finally, the crop matters. A young crop, a fruiting crop and a leafy crop each need different amounts, and a dense canopy may keep light from reaching the lower leaves.
A practical way to find out is to measure. Compare the light your crop actually receives, as DLI over weeks and not only single readings, with the target for your crop and cultivar. Also consider the photoperiod. Many crops have requirements for day length, so you cannot always move light freely from one part of the day to another.
How can growers correct a light shortage effectively?
You can correct a light shortage by first measuring the actual light, then making better use of natural light, and finally adding supplemental lighting where needed. The right solution depends on your crop, daylight, greenhouse structure and energy prices, so a plan tailored to your situation usually works better than a standard approach.
A step-by-step approach often works well:
- Measure: record PPFD and DLI at crop level over time to see how large the gap is.
- Make the most of natural light: keep glass clean, check screens and review the greenhouse layout and crop management.
- Define the target: set light intensity, DLI and photoperiod based on the crop, cultivar and growth stage.
- Add supplemental lighting if needed: choose horticultural LED or HPS lighting depending on your situation.
- Control it dynamically: adjust intensity based on daylight, accumulated DLI, crop needs and energy prices.
- Review the results: check the crop response and the climate, and adjust the strategy.
What should you consider with LED and HPS?
LED and HPS differ in more than electricity use. They also differ in light efficiency, light distribution, spectrum, heat output, investment and maintenance. HPS gives off more radiant heat, while LED gives off less. This changes the greenhouse climate, air circulation and plant transpiration. Neither technology is automatically the better choice for every grower, so consider your crop, existing technology, greenhouse height and energy costs.
How do dimming and spectrum control differ?
Dimming changes light intensity, for example in response to daylight, DLI targets or energy prices. Dynamic spectrum control changes the wavelength composition of the light. These are related but separate functions, and not every control system supports both. Check what your luminaires and software can actually do before you build a strategy around it.
For winter greenhouse lighting, the aim is not simply more light but the right light at the right time. Your DLI target, the photoperiod of your crop and the cost of energy should all shape the plan.
How Agrolux helps with greenhouse light shortages
We help growers move from a suspected light shortage to a lighting strategy that fits their greenhouse. We start from your crop, location, natural light, greenhouse structure, existing technology and energy situation, not from a product.
Our support can include light measurements and lighting plans, so you can see how much light your crop receives and how it is distributed. Our agronomists and plant scientists can advise on how light and spectrum may affect your crop and growth stage. We can also discuss LED and HPS options, including their effects on the greenhouse climate, and help with lighting control and energy management, so you can adjust light based on daylight, crop requirements and energy prices. Modular platforms such as LYRA™ allow you to start with one configuration and adapt or expand it as your requirements change.
If you suspect your crop is not getting enough light, we are glad to look at your situation with you. Visit the Agrolux homepage to get in touch with our specialists, or browse our portfolio to see the type of projects we work on.
Related Articles
- How can growers recognise signs of light stress in greenhouse crops?
- What Is PPFD and What Does It Tell You About Greenhouse Lighting?
- How can greenhouse growers optimise lighting during high electricity prices?
- How does luminaire ageing affect light output and efficiency?
- How does greenhouse lighting influence CO₂ uptake and photosynthesis?